b'13. Mark the center of the blue curve with a piece of tape. Place this on your Fjords spine at the tape marking the top of the wither, and push the blue curve around your Fjords wither and shoulder to trace that shape.15. Repeat the tracing of the back and rib shape at each of the other 4 tape lines across your Fjords back, transferring the shape to the respective hash mark on the paper. If its hot outside, put the curve in a bucket of ice water to keep it stiffer between tracings.14. Carefully, without distorting the shape, carry the blue curve to the paper. Place it on the wither hash mark at the 14.5 line. Use the square and yardstick to ensure the ends of the blue curve are perpendicular to the level line. Trace the wither shape onto the paper in that location. This uneven chimericshapeisbecauseIdidntensurethatRurikwas standing square. Try to not make that mistake when making your Fjords 3D model.16. Use the needle point pattern tracer to trace the spine shape that crosses the 7 line. The pin pricks will transfer the shape to the cardboard below the plotter paper.20 Fjord Herald Issue #149Winter 2023'