b'17. Use the square and yardstick to poke a line, from the20. Repeat this for each of the successive back/rib tracings front and back end of that 24 line, down to the edge ofthat you did.the cardboard. Do the same for each of the 5 hash mark locations.18. Remove the plotter paper and use the box cutter to cut out the resulting silhouette of your Fjords spine. Cut astrip of cardboard out at each of the hash marks, going no further than halfway down the silhouette from the topline.21. You now have a 3D model of your Fjords back, ribs and spine shape relative to level.19. Place the plotter paper back over the cardboard. Feel for where the edge of the cardboard is, and align that with both ends of the wither tracing. Hold the paper in place. Trace the wither shape with the needle tracer, and trace the center line,the14.5line.Removethepaperanduseyourbox cutter to cut out the wither and shoulder shape from the cardboard. From the bottom edge of that shape, cut out aslice of cardboard. This piece will now slide securely into the wither slot on your back silhouette.Fjord Herald Issue #149Winter 2023 21'